[TP-67A] Pairing (Re-syncing) Follow
How do I connect my TP67A?
If you can't see the OUT reading on your display unit, you may need to pair or re-sync your device with the remote sensor. Please follow this step:
With both units side by side, take the batteries out of the display unit and press the power button on the back of the remote sensor for 2 seconds until the indicator light, located on the front side of the remote sensor, blinks 3 times.
Once this is done, you can put the batteries into the indoor unit. Then, you'll have 3 minutes to turn the sensor back on by pressing the power button for 2 seconds again. The remote sensor should blink once this time and connect with the display unit.
Note: If more than 3 minutes have elapsed from the time you put the batteries
into the indoor unit and you haven't put the batteries into the remote sensor
you may have to repeat the pairing process.
Note 2: If you only get 1 blink from the remote sensor the first time you press
the power button, press the power button again and you should get 3 blinks.